 |
|
|
Shop > ACT > RD104
|
ACT Wall Mounted Dimmer Switch
|
|
|
|
 Enlarge Image
|
The replacement product is the RD134
X10/A10. Rated 600W, 120 VAC.
Applications:
- Dimmer Switch can store DIM levels for easy re-creation of lighting levels (scenes)
- Switch provides remote ON/OFF and Dimming control of lighting.
|
|
|
|
|
|
|
|
Description:
The RD104 is an A10 enhanced powerline carrier dimming receiver. Unit responds to On, Off, Bright, Dim, All Lights On, All Lights Off, All Units Off, and Status Request. A10 circuitry remembers last dim level for correct status report and restoration of dim level upon power up. Status LED on face is used for guide in programming (using keypads) and also indicates status. The RD104 is programmable to any of the 256 addresses, and for up to 64 relative scenes and 4 global scenes. The fade rate of the dimmer can be programmed from 1 second to 271 seconds over the entire dimming range, with 3.12 seconds being the default setting.
Features:
|
- Two way powerline communication, reports status
upon "Status Request" or Automatically
- Triac Output controlled by X10 On/Off, Bright/Dim or
Extended Code Preset Dim Signals
- Remembers DIM and SCENE levels, and restores after power loss
- Can control inductive loads
- LED indicates Power/Load Status/Programming
- Advanced A10 circuitry, X10 Signal Compatible
- Easy Push Button Programming for:
- Unit Address
- Fade Rate (between 1 and 271 seconds)
- Sixty Four Scenes stored in Non-Volatile Memory (no loss if power fails)
- Four Global Scenes in Memory
- Response to "Status Request"
- Enabling or Disabling "Polite Mode"
- Setting Status LED "ON" or "OFF" when load is off
- Washable Membrane Keypad Surface, available in White and Ivory
| Specifications |
| Power |
| Supply Voltage | 120 VAC, +/-10% |
| Frequency | 50 or 60 Hz |
| Signal |
| Signal Input | 120 KHz, X10 Powerline Carrier, sensitive to 25 millivolts |
| Signal Output (Status) | 120 KHz, X10 Powerline Carrier, minimum 6V peak to peak @ 5 ohm |
| Controlled Output |
| Internal triac | Enclosed, flying lead connections |
| Maximum switching power | 600 watts, 400 watts with break-off tabs removed |
| Fuses | One (1) .5 amp slo blow on control circuit, factory replaceable only |
| Mechanical Requirements |
| Dimensions | 2.7" L x 1.75" W x 1.6" H |
| Weight | Less than 16 ounces |
| Mounting | Mounting plate for standard electrical switch box |
| Connections | Flying Leads: BLACK (Line) -16 AWG, BLUE (Load) -16 AWG, WHITE (Neutral) -16 AWG, GREEN (Ground) - 16 AWG. |
| User Interface | Membrane Keypad w/ embossed LEDs |
| Environmental Requirements |
| Operating Temperature Range | 32 to 120 degrees F |
| Operating Humidity | 10% to 95% non-condensing |
|
|
|
|
|
|
|
|
|
|
|
|
The Smartest DIY Home Improvements
