 |
|
|
Shop > X-10 Pro > PUM01
|
|
|
 Enlarge Image
|
Contact closure and beeper. Trips a device connected to the dry contact; rated at 24V DC. Optionally emits a notification beep. Commonly used for drapery controls, sprinkler systems, garage door openers etc. Can be set for momentary or sustained contact closure. Available only in white. Plug-in Module.
The Universal Module allows you to control low voltage devices such as sprinklers, drapery controls etc. from an X-l 0 controller. It provides isolated relay contacts to control devices rated up to 5A at 24VDC (1OOVA at 3OVAC).
|
|
|
|
|
|
|
Setting up the Universal Module
- Using a small screwdriver adjust the code wheels to the desired House Code and Unit Code.
- Adjust the Momentary/Continuous slide switch as follows:
- Momentary causes the contacts to close for between 1.5 to 2.5 seconds when an X-10 ON command is received.
- Continuous causes the contacts to close when an X-1O ON command is received and remain closed until an X-l 0 OFF command is received.
- Adjust the other slide swItch to operate the sounder, relay contacts or both as required.
- Connect the terminals on the interface to the device being controlled.
Note: to avoid shock hazard do not connect devices rated over 30 VDC to this device.
- Plug the interface into a I20V AC wall outlet.
Testing the Universal Module
|
- Press ON to activate the module according to the selected mode.
- Press OFF to switch off The module if set to Continuous operation.
|
|
|
|
|
|
|
|
|
|
The Smartest DIY Home Improvements
