ELK-M1 Ethernet Port Interface - ELK-M1XEP
Allows M1 Gold to be connected to the Internet or LAN (network) for programming, monitoring, remote control, email notifications, etc. Requires permanent broadband connection; Cable Modem, DSL, T1,etc.
View Product Details
$214.21
ELK-M1 ELK Data Bus Wiring Hub - ELK-M1DBH
Data Bus Hub. For easy connection of expanders & keypads. The M1DBH accepts up to 9, RJ45 equipped CAT5 or CAT6 cables, and series connects the data A & B lines so the data bus may be terminated properly. Two or more units may be interconnected if more than 9 data lines are required.
View Product Details
$38.95
ELK-M1 ELK Data Bus Wiring Hub Retrofit (for existing 4 cond. wiring) - ELK-M1DBHR
An "active" RS-485 data bus hub designed for jobs where an M1 Control is retrofitting an older panel that has multiple homerun 4 conductor keypad/data wires. It splits the main 485 data bus into 4 managed 485 branches. Each branch can have 2 parallel home run cables for a total of 8 home runs. The end of each cable is EOL terminated to insure proper operation and supervision.
View Product Details
$56.95
Wired Expansion - Relays, Zone, Low Current
16 Zone Input Expander - ELK-M1XIN
Adds 16 hardwired zones (EOL resistor supervised) to the M1 or M1G Control. Operates from 4-wire data bus. Up to 12 of these can be used, increasing total zones (inputs) to 208.
View Product Details
$85.95
ELK-M1 ELK 16 Output expander, Voltage only - ELK-M1XOV
Adds 16 voltage outputs to M1 or M1G Control. Provides 2 plug-in, 8-pin flying lead connectors for triggering low current devices (50 mA max. each such as: LEDs, relays, piezos, etc. Operates from 4-wire data bus. Up to 12 Output Expanders may be used for a total of 208 outputs. The voltage outputs can be converted to relays (8 or 16) using (1 or 2) M1RB Relay Board(s).
View Product Details
$81.95
ELK 16 Output expander, 8 Voltage/8 Relays - ELK-M1XOVR
Adds 16 outputs (8 voltage, 8 relays) to M1 or M1G Control. Voltages can be used to trigger low current devices (50 mA max. each). Relays are SPDT rated for 7A @ 30 VDC, 10A @ 125 VAC. Operates from 4-wire data bus. Up to 12 output expanders may be used for a total of 208 outputs. Option: Convert 8 voltage outputs to relays using M1RB Relay Board.
View Product Details
M1 Accessory Wire Harness - ELK-WO35A
This 5-pin cable is required for connecting the wireless receivers (models NX408E, 416E, or 448E) to the M1 or M1G Control. It can also be used to connect another manufacturer’s proximity reader (26bit Weigand format) to a M1KP keypad. Wire Length = 18”
View Product Details
Wireless Receiver for NetworX Panels - NX-548E
The NX-548E receiver adds wireless capabilities to the NetworX line of control panels. Adding the receiver makes these control panels compatible with NX wireless transmitters. Only three wire connections are required to power and communication to the control panel.
View Product Details
The Smartest DIY Home Improvements
