The Smartest DIY Home Improvements

Home Automation, Security & Energy Savings

Phone Orders: 1-888-843-9103 | 631-361-3600

Motorola Homesight:
Everything you need to install a do-it-yourself home monitoring system for security, protection, and convenience.

Only $98.95!

Read More

View Video Demo »

Shop > Powerline Conditioning

Powerline Conditioning

	X10 PRO In-Line Noise Reducer - XPNR Wires in at the branch circuit or at the line leads of the affected module to help solve Hard-to-find or intermittent noise issues. View Product Details	$24.95

	X10 PRO 3-Wire Noise Filter - XPF Designed to filter out most signals above a frequency of 300Hz by attenuating the voltage of these signals by a ratio of 40 to 1. For installation at the fixture or electrical panel. View Product Details	$59.95

	Leviton DHC In-Line Noise Reducer - 6289 Filters electrical noise and signals with frequencies above and below the 121 kHz signal. The 6289 may be installed at the noise or signal source or at the module affected by the interference. View Product Details	$42.95

	X10 PRO Plug-in Noise Filter - XPPF For isolating a specific appliance. Plug the XPPF into the wall where the offending device was plugged in, then plug the device into the XPPF. plug View Product Details	$19.95

	ACT Plug-in Filter - AF120 Blocks noise from loads that interfere with Powerline Carrier transmissions. X10/A10 compatible. Rated 120VAC 15A. View Product Details	$21.95

	Leviton DHC Signal Attenuator - 6285 Installation of 6285 Signal Attenuator attenuates ("knocks down") external noise and signal levels entering the DHC network. It must be used in conjunction with a 6201 System Amplifier to boost the signals within the network. Rated for 2-Phase 120/240V & 120/208V AC 60Hz. View Product Details	$51.95

	Leviton DHC Noise Block - 6287 Prevents interference generated by fixture components from interfering with DHC signals. Rated: 5A 120V 60Hz AC only. View Product Details	$27.95

	X10 PRO 200Amp Coupler/Blocking Filter - PZZ01 Installs at the electrical panel to couple up to three phases. Also prevents X10 command signals from entering or leaving the building, effectively isolating the residence. View Product Details	$42.95

	ACT 20A Low Pass Filter - AF300 The AF300 is a Line Isolation Filter which filters out PCC command signals and any strong electric clutter at 120 kHz on the AC line. View Product Details	$58.95

	ACT 120-277 VAC,Two Wire, Low Pass filter - AF310 The AF310 is a Line Noise Attenuator which is parallel tuned and, therefore, attenuates noise and unwanted signals of frequencies above or below 120 kHz without attenuating the PCC signal. View Product Details	$21.95

	ACT 5A, High Intensity Discharge (HID) Choke - AC100 An HID choke intended for use with any PCC receiver where transient spikes from HID ballast may interfere with PCC command signals to the receivers. View Product Details	$9.95