 |
|
|
Shop > X-10 Pro > PMS03
|
X-10 Pro Eagle Eye Indoor / Outdoor Occupancy Sensor
|
|
|
|
 Enlarge Image
|
The Eagle Eye Indoor / Outdoor Motion Sensor (PSM03) sends wireless Radio Frequency (RF) signals to an X10 Transceiver (PAT01) or any X10 security system base receiver. The Transceiver receives the signals from the Motion Sensor and passes them onto your house wiring.
These signals are then received by X10 lamp, appliance, or wall switch modules to control lights (or appliances) around the home.
|
|
|
|
|
|
|
If you set the Eagle Eye Motion Sensor to a unique code (Housecode A and Unit Code 1), then walk into the room where the Eagle Eye Motion Sensor is located, a lamp module set to "A1" will turn on. As long as you keep moving, the light will stay on, and when you stop moving, the light turns off after the amount of time you select.
The signals transmitted onto your house wiring can also be received by the PC Connection Module (included with PC Home Control Starter Kit ) to initiate macros. The PC Connection Module then performs a sequence of events that you've set it up to do.
Normally the Eagle Eye Motion Sensor will turn on an X10 module set to its code, however when used with the PC Home Control Connection Module the Eagle Eye Motion Sensor becomes much more powerful. Instead of turning on a module set to A1, you can set A1 to initiate a macro that performs a sequence of events. For example you enter the room, the table lamp can turn on and dim to 70%, and the stereo can turn off 30 minutes later.
Built in photocell works like a watchful eye and will turn lights on and off at dusk and sunrise. This will save you energy as it only detects motion in the dark.
Features: Up to 20' foot range. Motion Sensor is 2.5 x 2.5 inches. (it's small so you can place them almost anywhere!)
|
|
|
|
|
|
|
|
|
|
The Smartest DIY Home Improvements
