Dimmer Switch can store DIM levels for easy re-creation of lighting levels (scenes)
Switch provides remote ON/OFF and Dimming control of lighting.
Item # RD104
Description:
The RD104 is an A10 enhanced powerline carrier dimming receiver. Unit responds to On, Off, Bright, Dim, All Lights On, All Lights Off, All Units Off, and Status Request. A10 circuitry remembers last dim level for correct status report and restoration of dim level upon power up. Status LED on face is used for guide in programming (using keypads) and also indicates status. The RD104 is programmable to any of the 256 addresses, and for up to 64 relative scenes and 4 global scenes. The fade rate of the dimmer can be programmed from 1 second to 271 seconds over the entire dimming range, with 3.12 seconds being the default setting.
Features:
Two way powerline communication, reports status
upon "Status Request" or Automatically
Triac Output controlled by X10 On/Off, Bright/Dim or
Extended Code Preset Dim Signals
Remembers DIM and SCENE levels, and restores after power loss
Can control inductive loads
LED indicates Power/Load Status/Programming
Advanced A10 circuitry, X10 Signal Compatible
Easy Push Button Programming for:
Unit Address
Fade Rate (between 1 and 271 seconds)
Sixty Four Scenes stored in Non-Volatile Memory (no loss if power fails)
Four Global Scenes in Memory
Response to "Status Request"
Enabling or Disabling "Polite Mode"
Setting Status LED "ON" or "OFF" when load is off
Washable Membrane Keypad Surface, available in White and Ivory
Specifications
Power
Supply Voltage
120 VAC, +/-10%
Frequency
50 or 60 Hz
Signal
Signal Input
120 KHz, X10 Powerline Carrier, sensitive to 25 millivolts
The Smartest DIY Home Improvements
