 |
|
|
Shop > ACT > RD114
|
ACT Incandescent Dimmer Fixture Module
|
|
|
|
 Enlarge Image
|
This product has been discontinued.
X10/A10. Rated 120 VAC, 300W.
Applications:
- Dimmer can store DIM levels for easy re-creation of lighting levels (scenes)
- Provides remote ON/OFF and Dimming control of lighting.
|
|
|
|
|
|
|
|
Description:
The RD114 is an A10 enhanced powerline carrier
dimming receiver. Unit responds to On, Off, Bright,
Dim, All Lights On, All Lights Off, All Units Off, and
Status Request. A10 circuitry remembers last dim
level for correct status report and restoration of dim
level upon power up. Status LED on service button
is used for guide in programming (using program
switch) and also indicates unit is powered. The
RD114 is programmable to any of the 256 addresses,
and for up to 64 relative scenes and 4
global scenes. The fade rate of the dimmer can be
programmed from 1 second to 271 seconds over the
entire dimming range, with 3.12 seconds being the
default setting.
Features:
|
- Two way powerline communication. Reports ON/OFFstatus
upon "Status Request" and automatically
- Triac Output controlled by X10 On/Off, Bright/Dim or
Extended Code Preset Dim Signals
- Remembers DIM levels, and restores after power loss
- Can control inductive loads
- LED indicates Power/Programming
- Advanced A10 circuitry, X10 Signal Compatible
- Easy Push Button Programming for:
- Unit Address
- Dim Rate (between 1 and 271 seconds)
- Sixty Four Scenes stored in Non-Volatile Memory (no loss if power fails)
- Four Global Scenes in Memory
- Response to "Status Request"
- Enabling or Disabling "Polite Mode"
|
| Specifications |
| Electrical Requirements |
| Power |
| Supply Voltage | 120 VAC, +/-10% |
| Frequency | 50 or 60 Hz |
| Signal |
| Signal Input | X10 Powerline Carrier, sensitive to 25 millivolts |
| Signal Output (Status Feedback) | X10 Powerline Carrier, 6V peak to peak @ 5 ohms |
| Controlled Output |
| Internal triac | Enclosed, flying lead connections |
| Maximum switching power | 300 watts |
| Fuses | One (1) .5 amp slo blow on control circuit, factory replaceable only |
| Mechanical Requirements |
| Dimensions | 2.7" L x 1.75" W x 1.6" H |
| Weight | Less than 16 ounces |
| Mounting | Double sided foam tape |
| Connections | Flying Leads: BLACK (Line) -16 AWG, BLUE (Load) -16 AWG, WHITE (Neutral) -16 AWG |
| Environmental Requirements |
| Operating Temperature | 32 to 120 degrees F |
| Operating Humidity | 5% to 95% non-condensing |
|
|
|
|
|
|
|
|
|
|
|
|
The Smartest DIY Home Improvements
