Smart Home Systems

 The Smartest DIY Home Improvements

 Home Automation, Security & Energy Savings
         
 Phone Orders: 1-888-843-9103 | 631-361-3600
                                  
 
Search
 
Shop

Save $ With Clearance Products!
Is price a major
factor for you?

We offer a large selection of discounted open-box items in our Clearance Section. These items are backed by our own warranties, so you have nothing to lose!
Clearance!
See Products
ยป


  Shop > Video Surveillance Systems >  > Logitech WiLife Digital Video Surveillance System > RD134
x10
  A10 120 VAC 300W Single Inductive Wall Mounted Dimmer Switch with Multi-Tap Feature
 
A10 120 VAC 300W Single Inductive Wall Mounted Dimmer Switch with Multi-Tap Feature
Enlarge Image
The RD134 is an A10 enhanced powerline carrier dimming receiver. The RD134 responds to ON, OFF, BRIGHT, DIM, and can be configured to respond to ALL LIGHTS ON, ALL LIGHTS OFF, ALL UNITS OFF, and STATUS REQUEST. Dimmer remembers last dim level for correct status report and restoration of dim level upon power up. Dimmer can also be configured to respond immediately to ALL LIGHTS ON and ALL UNITS OFF.

The RD134 is programmable to any of the 256 addresses, and for up to 64 relative scenes and 4 global scenes. The fade rate of the dimmer can be programmed from immediate to 271 seconds over the entire dimming range, with 3.12 seconds being the default setting.
Item # RD134
Select Options:
$43.95  
Shipping Rates
Free Technical Support
Low Prices Guaranteed!
Availability:
Item is Available
Display All:
ACT
Overview Specifications Manual FAQ More Info x10
Specifications
Electrical Requirements
Power Supply Voltage120 VAC, +/-10%
Power Frequency50 or 60 Hz
Signal Input120 KHz, X10 Powerline Carrier, sensitive to 25 millivolts peak to peak
Signal Output (Status)120 KHz, X10 Powerline Carrier, minimum 6V peak to peak @ 5 ohm
Internal triacEnclosed, flying lead connections
Maximum switching power300 watts, 200 watts with break-off side tabs removed
FusesOne (1) .5 amp slo blow on control circuit, factory replaceable only
DisconnectLoad Disconnect or Air Gap Switch on face disconnects load for service
Power Requirements
Dimensions2.7" L x 1.75" W x 1.6" H
WeightLess than 16 ounces
MountingMounting plate for standard electrical switch box
ConnectionsFlying Leads: BLACK (Line) -16 AWG, BLUE (Load) -16 AWG, WHITE (Neutral) -18 AWG, GREEN (Ground) - 18 AWG.
Environmental Requirements
Operating Temperature32 to 120 degrees F
Operating Humidity10% to 95% non-condensing
Note: Specifications may change without notice to improve product performance.
Return to Top
Contact Us |  Link To Us |  Copyright © 1997 - 2009 Smart Home Systems, Inc. All rights reserved |  Sitemap