 |
|
|
Shop > Channel Vision Central Products > Channel Vision Accessories > PSH01
|
X10 PRO PowerHorn 110 db Siren (aka PH508)
|
|
|
|
 Enlarge Image
|
For use with X-10 PRO Security Systems. Tripped by flashmode powerline signals from the main console. Plug in a few of them throughout the job site!
|
|
|
|
|
|
|
|
Installing the Power Horn
|
- Set the House Code wheel to the same house code as the Security System
Note: The house code for the Security System is downloaded by the security installation firm.
The deafult is 'A', when using the PRO2000 Security Panel.
- Set the Unit Code wheel to the same code as the security light from the PRO2000 download.
Note: If the owner does not wish the Power Horn to be triggered when the security light is
switched on, the security installation firm can re-configure the console to issue a sequence of
All Lights On/All Units Off commands during an alarm instead of flashing just the security light.
not be triggered when the security light is turned on.
- Plug the Power Horn into a convenient AC outlet, preferably an unswitched one to ensure that
the Power Horn cannot be turned off accidentally.
Testing the Power Horn
|
- Repeatedly, press the ON button, followed by the OFF button, (at least twice each) on any X-10
controller or remote, such as a PHC01 Mini Controller, which corresponds to the same House
Code and Unit Code as the Power Horn. After the siren starts, it will continue for 4 seconds
after the last command is transmitted.
- Trigger the security system by pressing the PANIC button on the console or on a remote. The
Power Horn will be activated automatically in the next 4 seconds after the alarm has been
triggered and will continue for around 4 seconds after the system is disarmed.
|
|
|
|
|
|
|
|
|
|
|
The Smartest DIY Home Improvements
