 |
|
|
Shop > X-10 Pro > PSX01
|
|
|
 Enlarge Image
|
This product has been discontinued.
Picks up X-10 RF signals, amplifies and re-sends them, increasing the range by up to 100 feet. Use up to 4 with X-10 PRO automation and 1 with the PRO2000 Security System .
The RF repeater is designed to increase the range of X-10 Pro RF security and home automation products by boasting and repeating RF commands from remotes and sensors.
|
|
|
|
|
|
|
The RF Repeater should ideally be located at a central location between the furthest remote or sensor and the transceiver module or security console with which it communicates.
Note: When repeating RF commands, in particular Home Automation commands, some delay in responding may be evident.
Installing the Repeater
|
- Find a suitable location, preferably at least 3ft above the ground and centrally located between the furthest sensor/remote and the transceiver or security console.
- Set the codewheel to position A. It more than one repeater is to be installed, set each code wheel to a different letter (A, B, C, or D)
- Plug the repeater into a 120 VAC outlet.
Testing the Repeater
|
- Set the codewheels on a lamp module to M1, plug a lamp into the module and plug the module into a 120 VAC outlet.
- Press the TEST button on the repeater end confirm that the lamp turns on.
|
|
|
|
|
|
|
|
|
|
The Smartest DIY Home Improvements
