 |
Did You Know?
You Get:
100% Free for Life
Technical Support:
- Before you buy
- After you buy
- Via Phone
- Via Email
- In our Forums
.. We're here for you.
Email Tech Support
OR between 9am-5pm EST: 1-888-843-9103
OR Post in the Forums.
|
|
|
|
Shop > X-10 Pro > XPSS-WI
|
X10 PRO Companion Switch for 3 & 4 Way applications
|
|
|
|
|
|
|
|
Installation Instructions for XPSS-WI
X10 PRO 125 VAC 3-Way Momentary Slave Switch
Before you Begin
- Read all Instructions
- Make sure your installation will conform to all applicable codes and requirements.
- Test for Signal Strength and Noise:
Using the XPTR Signal Strength Indicator and XPTT Signal Test Transmitter. It is necessary to test the installation in the actual operating environment. The amount and types of line loads may reduce the strength of the transmitted signal and/or electrical noise may cause interference with the transmitted signal. Proper installation may require additional couplers, filters or repeaters. Special coupling devices are required to allow signal to be distributed to all phases and zero-crossings in multi-phase and multi-transformer distributions.
There are no field repairable assemblies on this unit. It is covered by a two year limited warranty. If service is needed, the unit must be returned where purchased.
CAUTION!
Make all connections with the POWER OFF to avoid injury to the installer or damage to the device.
Carefully determine the 3-way (4-way, etc.) wiring for proper connections. Do NOT connect the CONTROL terminal on the XPS3 or XPDI3 modules to any LINE voltage.
Do not install the XPSS-I/XPSS-W at distances greater than 80 feet from the 3-way master modules.
- Strip 3/4" of insulation from the ends of the wires to make connections to the XPSS- l/XPSS-Was shown in the Wring Diagram.
- Check connections to be sure they are tight and no bare conductors are exposed.
- Make sure the load or installation does not exceed the device rating.
- Install into a standard single or rnulti-gang electrical wall box. Use a deep box to avoid interference with box fittings and allow room for wiring connections.
Mount the device in the wall box and install the cover plate/trim ring supplied (DecoraTM or compatible style cover plates for multi-ganged switches are available through electrical supply vendors).
CHECKOUT
|
- Restore the power.
- Test Local Operation: Depress the switch plate on the XPS3 or XPDI3 series 3-way Master switch several times to ensure the module turns the controlled load on and off in response to manual control.
- Test Slave Operation: Depress the switch plate at each XPSS-l/XPSS-Win the 3-way (4-way,etc.) circuit several times to ensure the module turns the controlled load on and off in response to manual control.
- Test Remote Operation: Using a controller, transmit "OFF', "ON", "ALL UNITS OFF' and "ALL LIGHTS ON' commands to ensure the device turns the controlled load on and off in response to remote control.
- Test for Signal Strength and Noise once again using the Signal Strength lndicator and Signal Test Transmitter.
|
|
|
|
|
|
|
|
|
|
The Smartest DIY Home Improvements
