 |
|
|
Shop > Xantech > 29110DBKIT
|
Xantech Hidden Link Standard Designer DLP/CRT Shelf-Top IR Receiver Kit (Black)
|
|
|
|
 Enlarge Image
|
This kit includes everything you need to control up to 4 A/V components stored behind closed doors with an IR remote.
The Hidden Link IR Receiver is a small shelf-top infrared repeater assembly. This kit includes an IR receiver and a 789-44 Connecting Block. The Hidden Link IR Receiver is equipped with a 7-foot cable and a 3.5mm stereo mini plug, which is plugged directly into the "IR RCVR" jack on the 789-44. It can also be plugged into the "AUX" or "IR RCVR" jack of other Xantech connecting blocks, such as the models CB60 and 791-44. The Hidden Link IR Receiver is primarily intended for use in installations where the connecting block is within reach of its 7-foot cable – as when installing the Hidden Link IR Receiver in a cabinet where the controlled equipment is behind closed doors.
FEATURES
- IR receiver receives commands from up to 30 feet away
- IR receiver is very small - only 2.00”L x 3.15”W x 0.70”H
- System testing red-talk-back LED confirms commands
- Includes 789-44 Connecting Block for easy system installation.
Prepackaged kit includes:
- (1) 29110D Shelf Top IR Receiver
- (1) 789-44 Connecting Block
- (1) 781ERGPS Power Supply
- (4) 283D Visible Designer Emitters
|
|
|
|
|
|
|
29110D IR Receiver:
- Infrared carrier frequency bandwidth: 30 - 100kHz
- Reception range: Up to 30 feet, depending on conditions
- Nominal reception angle: 55 degrees off axis
- Max. transmission length: 1 mile using 18 gauge wire
- Maximum current output: 100mA
- Drives IR emitters through Xantech Connecting Blocks, Controllers, etc.
- Dimensions: 2.00”x3.15”x0.70” (51mm x 80mm x 18mm)
- Power requirements: +12VDC, 10mA
789-44 Connecting Block:
- Inputs: 1 - Screw type 4-terminal plug-in. 1 - IR Receiver "IR RCVR" 3.5mm stereo mini jack
- Outputs: 4 - Emitter ports (3.5mm mono mini jacks) parallel driven
- Contains a 470 Ohm resistor in series with each emitter output
- Xantech 282, 283, 284 & 286 Mini Emitters may be used
- Power requirements: 12 volts DC. Uses 781RG or 782-00 Power Supplies. Note: A power supply is not
connected to the 789-44 when it is used as an emitter expander.
- 2.1 mm coaxial power jack
- Dimensions: 2-15/16" W x 1-3/4" D x 13/16" H
781ERGPS Regulated Power Supply:
- Input Power: 100-240VAC, 0.3A
- Output Power: +12VDC, 500mA
- 6 foot cable, 2.1 mm coaxial secure-fit plug
283D Visible Designer Emitter:
- Termination: 3.5mm mono mini plug
- Wire Length: 10 feet
- Blink: Visible, red
|
|
|
|
|
|
|
|
|
The Smartest DIY Home Improvements
