Need Help?
Cart

Evolve Z-Wave 20A Relay Fixture Module

Item # LFM-20

$54.95

This item weighs 0.50lbs.

In Stock

View all Evolve Guest Controls products

Product Description

The LFM-20 Isolated Contact Fixture Module is a component of the Evolve lighting control system. Wire the Isolated Contact Fixture Module according to the wiring diagram below and program it from the Wireless Controller to operate loads. Inclusion of this Switch on the Wireless Controller menu allows remote ON/OFF control of load connected.

This Isolated Contact Fixture Module is designed to work with other Z-Wave enabled devices. Z-Wave nodes of other types can be included on the network and will also act as repeaters if they support this function.

As part of a Z-Wave network, the LFM-20 will also act as a wireless repeater to ensure that commands intended for another device in the network are received. This is useful when the device would otherwise be out of the radio range of the wireless controller.

This module can be used to switch any load, including low voltage, as the relay is isolated from the power line.

Replaces the ACT ZRF113

Overview

A Z-Wave™ network can integrate devices of various classes, and these devices can be made by different manufacturers. The LFM-20 can be incorporated into existing Z-Wave™ networks. The button on the face of the LFM-20 can be used to carry out inclusion, association, or exclusion.

ADVANCED OPERATION

All On/All Off

The LFM-20 supports the ALL ON/ ALL OFF commands.

The LFM-20 can be set to respond to ALL ON and ALL OFF commands 4 different ways.

Refer to your controller for information on how to set the LFM-20 to operate in the manner you desire. Some controllers may be only able to set certain settings of ALL ON/ALL OFF response.

The 4 different ways the LFM-20 can be setup to respond to ALL ON and ALL OFF commands are:

  • LFM-20 will not respond to ALL ON or the ALL OFF command.
  • LFM-20 will respond to ALL OFF command but will not respond to ALL ON command.
  • LFM-20 will respond to ALL ON command but will not respond to ALL OFF command.
  • LFM-20 will respond to ALL ON and the ALL OFF command.

Wiring Diagram:

Specifications

  • Power: 120 VAC, 50/60 Hz
  • Signal (Frequency): 908.42 MHz
  • Maximum Load:
    • Isolated Contacts: 20 amps G.P. maximum, 277 VAC, 10FLA, 60LRA, 250VAC,
    • Motor: 1 H.P. maximum, 120/240 VAC
    • Incandescent: TV8 (Tungsten), 120 VAC, 960W maximum
  • Range: Up to 100 feet line of sight between the Wireless Controller and /or the closest Evolve Receiver Module

There are no field repairable assemblies on this unit. If service is needed, the unit must be returned where purchased.

DANGER! SHOCK HAZARD. Read and understand the instructions before installing. This device is intended for installation in accordance with the National Electric code and local regulations in the United States, or the Canadian Electrical Code and local regulations in Canada. It is recommended that a qualified electrician perform this installation.

For indoor use only. Retain instructions for future use.

Manuals for Evolve Guest Controls

No products are currently available from this category.
Unavailable/discontinued items are listed below for your reference.
Back to Top

Save Energy with Home Automation!

Find out how to save energy, money, and our environment by using the Smartest Home Improvements available. Want to Go Green?

Start Here

Plan Your Systems

Structured Wiring Systems

Complete Structured Wiring Systems from Leviton and ChannelVision Central.

Free E-Book: Home Automation Basics

Learn More